| |
|
|
|
|
|
 |
Power 750 Watts per channel into 8 Ohms (29dBW), 1100 Watts per channel into 4 Ohms
Voltage, RMS 77.5 Volts 20Hz to 20kHz
Voltage, peak-to-peak 219 Volts
Current, peak-to-peak 250 Amps
Damping factor 204
Output devices per channel 20
Loop out impedance 50 Ohms
Total harmonic distortion + noise < 0.004% 20Hz to 20kHz
Signal / noise ratio > 124dB 'A'-weighted
Input sensitivity for 750 Watts into 8 Ohms 2.4 Volts
Input impedance 100k Ohms
Channel separation > 93dB typical
Frequency response 20Hz to 20kHz, +0, -0.2dB
Input 1 pair line level RCA connectors
Outputs 2 amplifier channels via 2 pairs per channel binding posts, 1 pair RCA loop output sockets
Power requirement 100 / 115 / 230Volts AC 50 / 60Hz (factory pre-set),
2500 Watts at maximum audio power into 8 Ohms, 290 Watts idle
Amplifier 483 mm, 19 inches wide
167 mm, 21.8 inches high including feet
553 mm, 15.75 inches deep including rear terminals
Power supply 364 mm, 14.4 inches wide
167 mm, 6.6 inches high including feet
278 mm, 11 inches deep including rear sockets
Amplifier 34.1 kg, 75.1 lbs unit only, unboxed
45.2 kg, 100 lbs in shipping carton
Power supply 18.4 kg, 40.6 lbs unit only, unboxed
21.4 kg, 47.2 lbs in shipping carton
IEC mains lead - (16-Amp type) one, 2.4 metres (94.5 inches)
Low voltage interconnection leads two, 1.2 metres (47.3 inches)
Control interconnection lead one, 1.2 metres (47.3 inches)
|
| |
|
|
|
|
|
|
|
|
|
